Cleaning
- After using your Maddle, you should always clean each component of the product that was in contact with water.
- We recommend rinsing the product’s component with fresh water before using Maddle’s Paddleboard Cleaning kit to clean it. This product will not only clean, but also protect your board from UV light damages to a certain extent.
- You may also rinse the product’s components with fresh water before cleaning it with water and soap.
- It is also highly recommended to remove any sand / debris / particle from the Maddle Paddle junctions. Debris can find its way inside and make it hard to disassemble the Maddle Paddle.
- Also, to prevent cross contamination of microorganisms and bacteria, you must always thoroughly clean your product before using it on a different body of water.
*Please note that sand, rocks, saltwater and the sun will deteriorate the product over time. This is considered normal wear and tear and is not covered by the warranty.
Drying
- After cleaning your Maddle and all its components, it is necessary to dry the products, You can let them air dry, or to accelerate the process, pat them with a towel before letting them air dry.
- Never let water go inside of the board, whether by the valve or by a puncture in the PVC. This will create mildew and mold inside, which may damage your board.
- If you do not have the necessary equipment / space / time to clean your Maddle right after use, complete this process as soon as you can.
- Make sure to never leave your Maddle dry in the sun, as the sun’s heat can damage the board over time
*Please note that improperly dried products can cause the product’s print and dye to leak / transfer.
Comments
0 comments
Article is closed for comments.