How to use the electric pump?

Powerful Electric Pump (Max capacity - 20 PSI) : 

1. Connect the electric pump’s electrical cord to your car’s 12V outtake. If you wish to use your electric pump on the go, you may purchase the Maddle Portable 12V battery.
2. Make sure the air hose is connected to the INFLATE side of the electric pump to inflate.
3. Remove the valve cap of your maddle in a clockwise motion.
4. Make sure the valve is closed (the pin is in UP position).
5. Connect the electric pump’s air hose tip to the air valve by pressing down and twisting in a clockwise direction.
6. Set the desired air pressure between 15 PSI - 18 PSI.
7. Turn on the pump.
8. Keep inflating until your board reaches a desired pressure level reading. The pump should stop by itself once fully inflated.
9. You will hear a loud compressor noise once the board appears inflated initially. This is normal, the pump is not broken. The compressor is needed to increase the internal pressure to the required level.
   **For safety and usage, make sure the board is inflated to 15 PSI rather than 1.5 PSI. :)
10. Once the pump has stopped, disconnect the pump from the air valve by twisting in a counterclockwise motion
11. Once the pump has stopped, disconnect the pump from the air valve by twisting in a counterclockwise motion.
12. Close the air valve cap by turning it clockwise.

You may connect the air hose to the DEFLATE side of the electric pump to deflate your board in an opposite manner once you’re done using it.

Compact Electric Pump (Max capacity - 16 PSI): 

Our compact electric pump (orange and black) works similarly.

You may follow the steps above taking in consideration it does not have a deflate function and is capped at 16 PSI.